Suche

Volltextsuche durch die Inhalte unseres Internetauftrittes und durch das RÖHM Produktprogramm.

Suche

 
Eingaben löschen

Suchergebnisse

Bitte beachten Sie: Suchbegriffe unter einer Länge von 4 Buchstaben werden ignoriert.
66 Treffer:
51. DC0000336.PDF  
… where high speeds are involved, when machining asymmetrical workpieces or when using different top jaws. The chuck should be dynamically balanced with the workpiece mounted in accor dance with DIN ISO 1940 to…  
52. DC0000353.PDF  
… where high speeds are involved, when machining asymmetrical workpieces or when using different top jaws. The chuck should be dynamically balanced with the workpiece mounted in accor dance with DIN ISO 1940 to…  
53. DC0000364.PDF  
… Planscheiben, UGE/UGU Gußkörper, USE/USU Stahlkörper ZG cast iron body, ZS steel body with jaws stepped inward and outward -- ZGU cast iron body, ZSU steel body with hardened base and hardened or soft…  
54. DC0000352.PDF  
… where high speeds are involved, when machining asymmetrical workpieces or when using different top jaws. The chuck should be dynamically balanced with the workpiece mounted in accor dance with DIN ISO 1940 to…  
55. DC0000347.PDF  
… table at the bottom of this page. 7. Always use class 12.9 for screw fastening clamping inserts, top jaws, stationary locators, cylinder covers and similar elements. 8. The manufacturer undertakes no…  
56. 2503_04_E_Mandrels_and_Collet_chucks_web_En.pdf  
… KFG Sliding clamping mandrel KFG APPLICATION Turning of tubes and shafts Clamping via sliding jaws on two compensating clamping planes. The right-hand side is power-actuated, while the left-hand side is…  
57. DC0000366.PDF  
… and the sense of rotation. If and when possible, clamp the centring point in a vice fitted with soft jaws when mounting. Desatornillar el anillo roscado (8) (ancho de llave 8). Extraer el perno de sujeción (7)…  
58. DC0000399.PDF  
… functions required by the manufacturer of the machine. D If lathe chucks with quick-change base jaws are used, an electric interlock must prevent the machine spindle from starting in the ”jaw change”…  
59. DC0000346.PDF  
… switching functions required by the manufacturer of the machine. If lathe chucks with quick-change base jaws are used, an electric interlock must prevent the machine spindle from starting in the ”jaw change”…  
60. Betriebsanleitung_CoAE_Mech._1381527.pdf  
… is to be observed. In the case of mounting screws for clamping devices, clamping inserts, top jaws, rigid stops, pre-clamped covers, equalising weights and comparable elements, strength class 12.9 is…  
Suchergebnisse 51 bis 60 von 66