Suche

Volltextsuche durch die Inhalte unseres Internetauftrittes und durch das RÖHM Produktprogramm.

Suche

 
Eingaben löschen

Suchergebnisse

Bitte beachten Sie: Suchbegriffe unter einer Länge von 4 Buchstaben werden ignoriert.
66 Treffer:
41. DC0000350.PDF  
… the required clamping force for machining a workpiece, the centrifugal force of the clamping jaws must be considered (information for calculating the required clamping force are contained in the end of…  
42. DC0000394.PDF  
… shooting 10. Advise 11. Correct clamping of workpieces 12. Dimensions 13. Clamping ranges with top jaws, standard jaws, stepped jaws and carrier jaws 14. Spare parts and accessoires 3 5 9 9 9 11 12 13 14 16…  
43. DC0000871.PDF  
… piece 7. Maintenance 14 NC- 8. Clamping force diagram 9. Trouble shooting: See page 9 15 Claw jaws SKB – important information Intended purpose: Attention: All machine-specific accident prevention…  
44. DC0000368.PDF  
… 12.9 quality should be selected in all cases involving fixing screws for clamping inserts, top jaws, fixed stops, cylinder covers and similar elements. All fixing screws which, due to the purpose for…  
45. DC0000355.PDF  
… 11. Advise 12. Correct clamping of workpieces 13. Dimensions 14. Clamping ranges with SN top jaws, carrier jaws and soft top jaws 15. Spare parts and accessoires 3/4 6 10 10 11 13 14 15 16 19 20 21 22…  
46. RN_0914_DURO.pdf  
… ping chucks. Non--observation of this principle may lead to a loss of the 2. If special jaws are used, observe the following rules: residual chucking force, and as a consequence the work The jaws…  
47. DC0000358.PDF  
… Tellerfeder Name Body Base jaw, left Base jaw, right Screw spindle complete assembly Set of graded jaws Flange plate Fixing bolt Centre jaw, complete assembly Set of support rails Cover sheet Cover plate…  
48. RB-K.pdf  
… should not be less than 80% of the specified maximum clamping force. 17. For machine vice with jaws that can be shifted, sufficient residual clamping travel must be available in the final position. 18. If…  
49. DC0000365.PDF  
… onto the machine spindle 2. Test procedure (axial and radial runout) 3. Adjusting or exchanging jaws 4. Exchanging or expanding jaws 5. Care and handling 6. Chip protection 7. Safety advice and guidelines …  
50. DC0000345.PDF  
… where high speeds are involved, when machining asymmetrical workpieces or when using different top jaws. The chuck should be dynamically balanced with the workpiece mounted in accor dance with DIN ISO 1940 to…  
Suchergebnisse 41 bis 50 von 66